THE RENO LEDGER
ENTRY · 22.11.2026

Asbestos in older houses: where it hides

Asbestos is not a mystery material and it is not an automatic emergency. It is a group of fibrous minerals that was cheap, fireproof and easy to work, which is why it went into so many houses. The trouble for anyone renovating is that it hides in ordinary things. Nothing about a sheet of cladding or a patch of old vinyl announces what it is made of.

The age window

BRANZ's Level guide says asbestos-based products were widely used in construction from the 1920s to the mid-1980s. If your house was built or substantially altered in that window, assume some materials may contain it until you have evidence otherwise. The same guide lists roof tiles, wall claddings, vinyl floor coverings, sprayed fire protection, decorative ceilings, roofing membranes, adhesives and paints among the commonly used products.

Two things follow from that list. First, asbestos was not confined to the sheets everyone thinks of. Second, the material you are about to remove may be a layer, such as the adhesive under a floor covering, rather than the thing on show.

Places to look

Think of the house room by room, and think about what is likely to be disturbed by the job you have planned.

Why it matters, and why it is easy to underestimate

Asbestos fibres cause asbestosis and lung cancer when inhaled. Level points out that symptoms often take 15 to 20 years to appear, which is part of why the danger is underestimated, and that most work-related deaths in the building industry result from asbestos exposure. Mesothelioma claims to ACC were actually higher in 2020 than in 2010.

On the other hand, Level is also clear that products in sound condition that are left alone do not pose a major risk. The risk arrives when materials are cut, sanded, waterblasted or broken up. That sets the logic for a renovation: find out what is there, then decide whether to leave it, seal it, enclose it or remove it. Health NZ lists those same options for householders.

Testing before you disturb anything

If you suspect a material, get it tested by an accredited laboratory before the work starts. Level says laboratories need roughly two $2 coins' worth (about 2 by 3 centimetres) of cladding or flooring, and about a tablespoon of a decorative ceiling finish, including any sparkly or stipple material. Take samples carefully, damp the area, and bag them. Do not sand a ceiling to find out whether it is a problem.

The practical point is that results take time, so test early. A demolition day set before the lab result arrives is how people end up guessing.

What the removal rules say

The Health and Safety at Work (Asbestos) Regulations 2016 set out who can remove what. Level summarises the licence classes:

Licensed removal work has to be notified to WorkSafe at least five days before it starts, and a licensed assessor inspects completed Class A work and issues a clearance certificate. Check what WorkSafe currently requires, because its asbestos guidance is being updated.

The penalties give a sense of how seriously this is taken: Level reports a $150,000 fine in an Auckland court in September 2019 after a careless demolition job that included failing to manage asbestos.

If you do small, unlicensed work

Work that does not need a licence still needs care. Level's precautions include sealing off the work area, wearing disposable overalls and a cap, using a suitable respirator for asbestos dust, keeping the material damp, and cleaning up at the end of each day. Do not waterblast asbestos-based material, and do not break sheets or drop them. Residues go in sealed, clearly marked bags, and disposal is at a place approved by the local authority. Vacuum with a HEPA-filtered cleaner and wet mop afterwards.

That is the baseline for small jobs. Ceilings that carry textured coatings are a particular case because the fibres can be in the finish itself, which is why guidance on asbestos and textured ceilings is worth reading before anyone picks up a scraper.

Planning a renovation around it

The sensible order is:

  1. Identify likely materials from the age of the house and the list above.
  2. Test suspect materials before demolition or sanding.
  3. Decide for each material: leave, seal, enclose, or remove.
  4. Engage licensed removal where the rules require it, and allow for the notification period.
  5. Only then start the demolition, sanding or re-lining work that follows.

A painting contractor that works on older homes, for example Eggshell & Co, will normally ask about ceiling texture and the age of the house at the quote stage, and that is a good signal that they take it seriously.

Where to get advice

Your public health service can advise on what to do if you think you have asbestos at home, and Health NZ's pages cover identification and options. WorkSafe publishes the current rules for removal. Rules and guidance change, so check the latest versions.

Sources

SEE ALSO: Treating timber before the walls are closed up; Subfloor work during a renovation; Stripping wallpaper in an old house
The Reno Ledger records what is worth knowing before and during the renovation of an older New Zealand house. General information; check consent rules with your council.